Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I have a Hitachi C 7SB2 circular saw that has very few hours on it, but is perhaps 10 years old. I cut a piece of wood, put saw down, then tried to cut a second piece, but the saw would not run. I checked the outlet for voltage, and it was fine. Checked the cord for continuity, which was also fine. Checked the switch by opening the case, and found that current is getting past the switch. I then bypassed the switch, but the saw still would not run. I removed the brushes and checked for voltage at the brush terminals, and found that it had 120 volts. Finally I opened the saw case to check for obvious damage to rotor or stator, though I did not remove the stator.

Is there any test that I can do with a multimeter, or other device to check further?

I don't see any electronics in the parts diagram.

share|improve this question
add comment

2 Answers 2

Most Table saws have an overload reset button on the saw somewhere

share|improve this answer
add comment

" ... a spindle lock provides an extra level of safety" from the product description on amazon. If that is not the cause, I'd phone Hitachi customer support.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.