Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I am starting a DIY project to create a standing desk. Part of this project involves installing some electronics in the wooden desktop itself. I need to make the following cuts / carvings and am wondering the best tool to use:

  1. A 10" x 10" square on the surface of the desk that is 1" deep
  2. A 2" x 10" rectangle on the side of the desktop that is 2" deep

I am hoping there is a handheld power tool that can help me accomplish this. I don't need perfect cuts; a hand-made imperfect aesthetic would be just fine.

share|improve this question
add comment

2 Answers

up vote 3 down vote accepted

The tool you are looking for is a Router:

Router

If going the manual route, chisels would do the job too:

Chisel

share|improve this answer
    
Thank you very much for the information. Researching now! –  bitpshr May 2 '13 at 18:55
1  
I would be a bit more precise on the router and suggest a plunge router. It allows to easily make cuts on a surface. Fixed routers are more useful for edge work. –  Maxime Morin May 3 '13 at 0:27
add comment

I agree with Steven that a router is the way to go. However, I think it important to point out a few things to consider if you use a router for the project you described, especially if you have never used a router before.

First off, you shouldn't try to cut the full depth of the pockets you describe in a single pass. You will need to make several passes, taking out a little bit at a time. The amount you should take per pass depends on the material but I would start with 1/4" or less. The less you take the easier it will be to control the router.

Second, let's consider for a moment that the base of the router pictured above is about 5" diameter. You need to keep about half the base (at least) pressed against the surface to maintain control of the router. How will you route the center section after the first pass if your hole is 10" square? The answer is you need to make a larger base, one that will span both edges of your hole. Most routers are made so the base can be removed so you can make and attach a custom one for instances such as this.

Third, generally you should move a router against the rotation of the cutter in order to prevent the cutter from grabbing. If you are using the router handheld and working on the inside this means you should be working in a clockwise spiral around the inside of the pocket you are cutting.

Finally, it is always easier to control the router if you are working against a guide surface. A template router bit has a bearing above the cutter which you can ride against either a template or at least a straight edge. I think it is the right cutter for this job. Even if you don't make a complete template you can clamp a straight edge to the each edge of the pocket in succession to establish the outside edges.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.