Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

The guy I hired to frame for a new pocket-door, mounted the pocket-door box on the top (to a second-story joist) and on the bottom (toe-nailed to the floor). When I asked him to install some studs on both sides of the door, he said I don't need them because I can nail my wall material (1/2" plywood) right into the horizontal planks of the pocket-door box. I have a feeling that would be wrong, or at least not up to Code. What do you think? Any advice is very much appreciated. I am new to this, just learning the terms. But it really didn't seem safe..

share|improve this question
add comment

1 Answer 1

The 'boxes' made for pocket doors are designed to act as the framing for your wall material (typically sheetrock). You topically can't frame out the pocket door pocket with full studs as that'd make the wall too thick.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.