Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

This question already has an answer here:

I have an older furnace, on the switch block I have Y,C.W,R and an unlabeled screw that connects to the shut off it looks like. I need to hook up a thermostat that needs the C wire. I have a spare wire, in the bundle which I hooked up to the c terminal downstairs, from these videos that I've seen it tells me to then bridge the Y and G together, I do not have a G on the block, what do I need to do to get the neutral wire set up

share|improve this question
    
Forgot to add that I have gas heat only –  Brian Miller Mar 7 '13 at 17:07
    
What is the make and model of the furnace? –  Tester101 Mar 7 '13 at 17:27
    
After more testing I discovered even though its a c wire, it's not pulling 24v, so I'll need to add another 24v to the one wire –  Brian Miller Mar 7 '13 at 17:32
    
It's only a C wire, if it's attached to the C terminals at both ends. It sounds like you're not sure what you're doing, you might want to contact a local HVAC technician before you fry your furnace. –  Tester101 Mar 7 '13 at 17:37
1  
This answer might be helpful. –  Tester101 Mar 7 '13 at 18:26
show 3 more comments

marked as duplicate by Tester101 May 10 '13 at 11:55

This question has been asked before and already has an answer. If those answers do not fully address your question, please ask a new question.

1 Answer

You have a C wire, so use it - you don't have to bridge as that is only necessary if you don't have a spare wire.

share|improve this answer
add comment

Not the answer you're looking for? Browse other questions tagged or ask your own question.