Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I'm going to stiffen up my main floor joists by sistering then bridging them. In the past a friend put something in the middle, is that standard? Should I put 1/2" plywood or OSB in between?

share|improve this question
add comment

1 Answer 1

up vote 4 down vote accepted

There is no real reason to put a spacer between the joists when sistering them. Usually using some 1/2 plywood between dimensional lumber is to correct the thickness to vertical lumber dimensions, like on a header over a door. If you were to add a spacer, I would use plywood as OSB has much less sheer strength. Adding some plywood will add a bit more strength, but in your case, may not make a difference.

share|improve this answer
    
spacer not needed, it doesn't upgrade header/beam span limits when used, just as shirlock has mentioned –  HerrBag Feb 27 '13 at 0:08
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.