Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

How can I remove a single damaged floor tile without damaging the surrounding tiles? Is there anything that will help the replacement tile from cracking in the same way?

share|improve this question
    
this is relevant to my interests... –  Doresoom Jul 22 '10 at 13:24
add comment

4 Answers

up vote 7 down vote accepted

I'd grind/scrape away the grout first and then gently tap the middle of the tile with a screwdriver until it shatters and chip it out. It'll probably take a while to do it but you should be able to scrape/chip away the old thinset, apply new thinset then regrout.

best of luck !

share|improve this answer
2  
Safety tip: Wear eye protection while chipping the tile. –  Chris Cudmore Sep 17 '12 at 14:42
    
@Chris Cudmore - yes yes and yes !! this is definitely a time when you'll need safegy glasses or even a plastic face shield. Tile chips are thin, sharp as all get out, and they fly everywhere when struck. –  Scott Vercuski Sep 18 '12 at 17:37
add comment

The first step is to remove the grout around the broken tile using a grout cutter. It’s important to make sure that you don’t chip the surrounding tile.You can then use a rotary tool or a utility knife to cut the down-ward facing tabs on three of the four sides. Be sure to use the appropriate care and safety equipment when using the rotary tool or utility knife.Next carefully remove the broken tile by lifting and pulling away the uncut side.Then, remove the downward-facing tabs on three of the four sides of a new tile with a utility knife.Next apply a layer of adhesive and set the new tile into position.

share|improve this answer
add comment

YOu can cut out the grout with a grout saw. Be sure to not try to pry the tile up on the edges because you can easily damage the edge of the adjoining tiles. It you lightly tap the tile in the middle and break with a hammer, you can then remove the tile from the middle area, working to the outer edges.

You must remove all old thin-set by chipping or grinding it away. Apply new thinset to the back of the new tile and place. Wait approximately 12 -14 hours than grout the new tile into place.

Thanks captainbay

share|improve this answer
add comment

There is a dremel tool called the multi-max that I have used before. You can get a diamond attachment for it that will cut through grout like butter. Once you get the grout out you should be able pop up the tile and replace it.

share|improve this answer
5  
after removing the grout, I'd drill a few holes in the tile surface two to "break it up" for easier removal –  MGOwen Jul 29 '10 at 3:19
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.