Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

So I've got an older house, built in the late 1950's. All the lights in the bathroom fixtures and the garage are fluorescent. Sometimes, but not always, they take several minutes to actually turn on when you flip the light switch. I can see that there's a glow at the ends of the tube when they do this. I've tried switching out older light tubes for newer ones, but it doesn't seem to matter. What's going on with this? Why do these lights do that? Any way to fix it?

share|improve this question

2 Answers 2

Since you've got an older house, your fluorescents probably have starters. Fixtures that take a long time to turn on may have a bad starter. I'd look into replacing the starter if you can find a matching one - it should be a relatively cheap alternative to replacing the entire fixture.

share|improve this answer
3  
Another possibility is that the starter isn't rated for the wattage of the bulb. Either way though, you'll need a new starter. –  Niall C. Oct 26 '10 at 21:44

If its cold (unheated garage). Your fluorescent fixtures could have problems.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.