Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I am replacing a bath fan/light with a fan/light/night light combination fixture. I need a new wall switch with 3 controls. I currently have just a cable with hot, neutral and ground running through conduit to the fixture.

What kind of additional wires do I need and how do I connect the switch to operate each function independently?

share|improve this question
    
Is wire from the breaker coming to the existing switch box currently or is it run to the light? Is it a second floor bathroom where you have access to the attic and could potentially run additional wires? –  maple_shaft Jan 14 '13 at 18:49
    
Yes to both of your questions. –  Jack Jan 14 '13 at 21:21
add comment

2 Answers

I just installed one of these combo fan/light/nightlight fixtures in my bathroom.

We used a Leviton triple rocker switch like this one: Switch

We used cable with 4 wires between the switch and the fixture. The hot wire goes into the switch. The neutral connects to one of the 4 wires, the other 3 connect to the switch.

At the fixture, the neutral is connected to the neutral wires for all 3 functions (if there are 3 wires, there might only be one), and the 3 switched wires connect to the other 3 functions.

share|improve this answer
add comment

The fan/light combo is intended to be controlled by three switches, however this isn't entirely necessary. The easiest way to deal with this without running any additional wires would be to wire nut together the fan and the light to the black lead from the switch and then just wire nut together the neutral. The night light in this instance will not really have a meaningful function as the primary light will always outshine it, so you can just cap that off with a wire nut.

The consequences of the above is that when you turn on your light, you will also be switching on your fan at the same time.

If you don't wish for the above then the other option is to run 12/4 (20A circuit) or 14/4 (15A circuit) from the switch to the overhead fan/light box. This isn't too bad if you are in the middle of a remodel and there is no drywall up, or if your bathroom is on the second level and you have access to the attic. Simply dropping the line down from the attic is possible if there is no insulation in side of the walls to get in your way. If neither of these are your case then running the new wire from the switch box to the fan box will probably involve you cutting drywall in your bathroom ceiling.

Once you have properly dropped the new wire in place, you can use each individual colored wire from its own switch, and have the black hot wire from the circuit breaker wire nutted to all of the colored wires in the switch box.

share|improve this answer
    
Why the down-vote? Am I wrong about something? –  maple_shaft Jan 15 '13 at 2:13
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.