Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I've been researching drywall finishing techniques and have noticed that when a first coat of mud compound is used, a smaller 6 inch taping knife is used... then on the second mud application, a larger knife is used (usually 6 - 12 inch)... then on a third coat, a 10 - 12 inch knife is used.

Is this just personal preference? Why are progressively larger drywall knives used after each pass?

-M

share|improve this question
add comment

3 Answers

up vote 13 down vote accepted

You're spreading the mud out over a progressively larger area so that instead of a small but sharp bump (or dip) in the middle of the joint, you have a much more gradual bump (or dip). That way, any irregularities in the surface are much less noticeable and can be easily masked by texturing.

share|improve this answer
add comment

Note that that progression only applies for "butt" joints where the unshaped short edges of drywall panels meet, not to long-edge joints where the edge is thinner to create a recess in the finished wall. On those edge joints, you just want to fill up the recess not bulge and feather it, so your knife only needs to be long enough to span the recess, or about 6-8".

share|improve this answer
add comment

I know the question is already solved but I learned a lot over the weekend watching drywall videos on YouTube. There are a number with Laurier Desormeaux posted by drywallgall that were really good.

share|improve this answer
    
I reccommend drywallgall's videos whenever I can. I used to hate drywall now I love it... –  dfc Feb 25 '13 at 3:12
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.