Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I have a bunch of pattress boxes to fit for light switches and plug sockets and was wondering if my oscillating multi-tool could be of any use.

I have a Bosch PMF 180 E Multi. Can this be used to cut the outside edges for a pattress box in a brick wall?

If it can then what attachment should I use... there are so many!

share|improve this question
add comment

1 Answer

up vote 0 down vote accepted

Bosch lists a segmented blade HM-RIFF that it says will cut grooves in porous cement, small cutouts in soft wall tile. I guess four grooves would make a cutout. A lot will depend on the thickness of the brick,.Are you looking to cut thru a brick veneer or the entire thickness of a conventional redbrick? I would try to get a similar material to practice or trial cut. The width of the blade looks a little wide to cut the short sides. You may be able to make a series of long cuts then chip out the segments.

share|improve this answer
    
I gave it a go with this attachment and it worked pretty well... definitely came out neater than previous attempts –  Edd Apr 30 '13 at 14:43
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.