Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I have a well and a pressure tank. I lost water pressure last night and thought everything was frozen but it wasn't, however, the regulator was not engaged. I engaged the pressure regulator and the water was flowing through the pipes in the house. Now when the cold water is used in the house the water heater pulsates. What could be the cause of this?

share|improve this question
add comment

1 Answer

Sounds like the pressure regulator is failing and needs to be replaced. Last time mine went, it would bang all the pipes after I used any water, hot or cold. Depending on your existing pressure regulator and the replacement you find, it may be as easy as unscrewing the old one and screwing on a new one. But more than likely, you'll need to cut the pipe and solder (assuming copper) a new connection or two.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.