Tell me more ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.
up vote 3 down vote favorite

one of my steam radiators has a leak on the bottom, away from the valve (has been checked, my husband has changed out the valve). can I use a spray sealant to seal this leak? (like FlexSeal)

share|improve this question

2 Answers

up vote 2 down vote

From reading on the Internet, FlexSeal looks like a scam ($59.70 for shipping, signs you up for $29/month "membership" without asking). It looks like it's similar to automotive rubber undercoating, which you can buy locally for ~$5 per can.

Don't know if it would work for your purpose. But I can recommend J-B Weld. Sand and clean with acetone, then apply a thin (1 mm) layer of J-B Weld. See also the answers to this question.

share|improve this answer
Typically, for anything under pressure, you have to seal it from the inside so the pressure drives the sealant into the porosity or hole. The sealant also has to adhere and also flex under temperature expansion. Marine-Tex and J-B Weld probably are the only sealants you'll have success with on external application. I've used Marine-Tex on engine block cracks, J-B Weld is formulated for similar use. As Vebjorn says, sand it down till you find metal, clean it of all oil and apply. – Fiasco Labs Jan 6 at 3:43
up vote 1 down vote

drill a hole in the leak, tap it pipe thread, install dope with pipe plug

or weld or braze or solder

share|improve this answer
This would be the best, there are radiator restoration businesses that could clean the leak area and hit it with a bit of silver solder (high temp) and end the problem permanently. It requires someone with experience heating cast iron. – Fiasco Labs Jan 6 at 3:47

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.