Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

My garbage disposal is leaking water and black sludge under the sink and it makes the whole house smell horrible. Can I easily fix it?

Edit:

Here's a picture of it:

gargabe disposal leak

the leaked water/sludge is circled in red at the bottom. As you can see the leak appears to be coming from the plumbing that is taking the stuff away from the GD.

share|improve this question
    
probably. But it depends. –  DA01 Dec 22 '12 at 23:06
    
Can you post a picture of the pipes and possible point where you think the leak is? –  mikes Dec 22 '12 at 23:13
    
added photo of leak –  Ryan Dec 22 '12 at 23:51
add comment

1 Answer

up vote 4 down vote accepted

If it's coming out of the motor casing, the seal under the shredder plate has failed. The whole unit needs to be replaced. Repair is pointless as the garbage disposal will have other corrosion issues.

From Photo It's coming from the trap joints. There's a square cut rubber gasket under that screw collar that's probably hardened, cracked and is the source of the leak.

Get a bucket under the trap ("U" section) loosen the collars that hold it on and pull the trap out. It'll be full of gunk. Since it looks like there's rust on the outside, clean it really well and make sure it's not ready to corrode through. Replace anything that is ready to rust through. The tailpiece (what goes into the septic plumbing) also has a collar, take it loose and clean that piece as well. Replace all the gaskets and put it all back together.

Make sure the black "L" bend that comes out of the disposal unit protrudes far enough into the trap "U" when you put it back together so that the gasket seals. One problem I've come across is that the installer cuts it too short and it works its way down till the gasket fails to seal and it starts to leak.

share|improve this answer
1  
don't think it's coming out of the motor casing. see new photo in OP. –  Ryan Dec 22 '12 at 23:52
1  
Collar gasket on the slip joint is compromised somehow, either cracked or if the black piece coming out of the disposal is too short, has slipped down so the seal gasket can't grip it. –  Fiasco Labs Dec 23 '12 at 0:13
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.