Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I broke my PVC toilet flange when I over-tightened the bolt used to secure the toilet to the flange. How do I fix this without replacing the entire the PVC fitting? This PVC flange is glued to the drain pipe so I can't just pull out the fitting to replace it.

Here is what it looks like, the red circle shows where the bolt was the snapped the flange. enter image description here enter image description here

share|improve this question
add comment

2 Answers 2

up vote 5 down vote accepted

You can purchase a toilet flange repair at any big box hardware store.

Remove the wax ring (buy a new one), remove the bolts, and mount this on top of the existing broken flange: enter image description here

Then reattach the toilet as per normal, making sure not to over tighten.

Tip, seat the toilet firmly on the wax ring before you tighten the bolts, and use a STANDARD sized wax ring not a jumbo - if the toilet starts out firmly on the floor before you start tightening then you know you're tight enough when the washer starts to bend in just a little.

share|improve this answer
add comment

You may also be able to get toilet bolts that screw into the wood. That is, if you have a wood floor under the flange.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.