Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I plan on installing three LED security lights to my home. I would like to have them turn on and off with a photocell. I am going to have a switch and then install the lights in parallel. I am not sure how to add the photocell.

I have also read that some photocell act like dimmers and I know that won't work with an LED. Is there a way to know if the photocell is a switch or a dimmer?

share|improve this question
add comment

1 Answer

There are certain photocells that are only rated for incandescent bulbs and there are also photocells that are rated for L.E.D and flourescent bulbs. You would have to make sure if yours will allow L.E.D.s The same goes with dimmer switches. A dimmer that is only rated with incandescent bulbs, if hooked up to a led or flourescent (cfl) bulb will eventually burn out. Again you have to make sure u find the correct photo cell. also to you will install the photocell between the switch and the 1st light in the series of light. It will be

Power comming into the switch > power from the switch to the photo cell > power from the photo cell to the light and so on....

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.