|
I have a flat pack shelving unit to put together. it has double ended screws. according to the instructions you just screw them in using you hands. This is impossible, the pre drilled holes seem way too small for the screws. I am unable to screw a nut on to tighten with a spanner as it is two normal screws stuck together not the usual version. suggestions anyone? this is driving me nuts! |
|||
|
|
|
Double ended screws are only used where you can spin the two pieces together. Don't screw in one and, then the other. There is no need for a wrench in the middle. This will usually only bung up the threads. Start the screws in both holes at once, just as far as your fingers will start them. (That won't be far, nor does it need be.) Just turn the pieces. Both ends of the screw will feed in at once. This works because if one of them gets too deep, it will have more friction, allowing the other end to catch up. |
|||
|
|
|
Since the double ended screws are typically for attaching two wood surfaces together, start the screw in one of the pilot holes (just enough to stay put). Then align the other pilot hole and spin one or both pieces of wood together. For example, if this is the below end cap on a wood pole, you'd put the screw on the end of the pole so that it doesn't fall and then spin the cap on until the screw is embedded in both surfaces and they are tight together. The only time you need the use pliers on the center piece is if you need to remove the screw.
|
||||
|
|
|
Does the screw look something like this:
You can see that there is a piece in the middle that doesn't have a thread and is faceted rather than round. You should be able to use a small spanner or pair of pincers to screw it into the first piece. The other solution is to make the pilot hole slightly larger so you can screw it in with your hands. |
|||||||||
|
