Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I have SmartLabs dimmers #2476d in my house and some will turn on all the way on a single tap while other turn half way and then when tap second time they go all the way.

Any idea how I can configure those that go all the way to turn on half way on first tap? Am I making sense?

share|improve this question
add comment

1 Answer 1

up vote 3 down vote accepted

To set your INSTEON dimmer module's On-Level:

  1. Use either the local buttons on your dimmer module or a Linked INSTEON Controller to adjust the light to the desired brightness.

    Press & hold the On button on the dimmer module or Controller to brighten the light. Release at the desired brightness.

    Press & hold the Off button on the dimmer module or Controller to dim the light. Release at the desired brightness.

  2. Once the desired brightness has been achieved, tap the Set button on your dimmer module once.

    The load will flash. Some INSTEON models will beep once. The local On-Level has now been set.

  3. Test the On-Level settings by pressing the On/Off buttons on your dimmer module.

For full reference, use the manual: http://wiki.smarthome.com/index.php?title=2476D_Manual_(Rev_5.0)#Setting_the_On-Level

Note that if you link within 4 minutes of setting the level, it will be used as the link on-level instead, so don't link it if you're trying to set the local on-level (as you are).

share|improve this answer
    
Perfect, worked like a charm! Thanks! –  sergeb Nov 6 '12 at 5:51
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.