Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

We're installing an engineered wood flooring in a room that already has a plywood subfloor. The engineered flooring will be 1/4" shy of the height of the hardwood in the other rooms, so I'd like to make up that difference underneath. My original thought was to use 1/4" XPS but that seems like it may not work.

If I go the 1/4" plywood route, what kind of connection do I need between the two subfloors? Can I just float the 1/4" on top? Or do I need to affix them together? If the latter, would some 1/2" brads be enough? Do I need to glue and screw?

share|improve this question
3  
I'd screw, not glue. Definitely not brads. Just enough screws to keep them in place, mind you, no need to go overboard –  GdD Oct 24 '12 at 20:51
add comment

2 Answers 2

You could simply install a transition piece between the two rooms.

But if you're determined to get them to match up, then 1/4" luann board will do nicely. Glue and screw - 1/4 bead of glue distributed evenly over each board, screws on a 1 foot grid.

NOT going overboard is what leads to squeaky, shifting sub-floors that make for a shoddy looking finished product.

share|improve this answer
    
screwing down some luann is fine, a layer of red rosin paper between layers will also avoid squeaks. I would put down some adhesive personally, takes out any bounce as well as squeaks. –  shirlock homes Oct 24 '12 at 23:49
    
What about using a cork underlayment instead of luann? Since it's engineered, cork won't interfere with the attachment of the wood flooring. Plus it'd give a nice sound dampening effect. –  Malfist Oct 25 '12 at 14:19
    
I don't understand why it's being engineered vs. not engineered has any impact on the attachment of final flooring? –  The Evil Greebo Oct 25 '12 at 14:49
    
I think he means it's a floating floor (because it's an engineered floor) so don't have to worry about glue/nails. –  DA01 Oct 27 '12 at 18:27
    
Exactly, engineered wood floors are often floating floors and don't need to be nailed down. –  Malfist Oct 29 '12 at 12:18
add comment

Have you considered using cork as an underlayment? I believe they make them in various thicknesses, including 1/4". It's very easy to work with (you can cut it using a utility knife) and it helps dampen sound.

share|improve this answer
    
that's an interesting option! I'll need to look into that. –  DA01 Oct 27 '12 at 18:26
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.