Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I want to cut a piece of plastic peg. The peg will be visible (it is on my laptop stand), so want it to have a smooth finish. I could just use a saw, but the finish will not be good. How should I go about it? I am not sure if a file will be enough to get a proper finish.

share|improve this question
Saw blades with more teeth produce a finer cut - you might be able to use a saw if you have the correct blade –  Steven Sep 24 '12 at 12:40

4 Answers 4

up vote 5 down vote accepted

I would recommend cutting the peg(s) using a fine toothed saw like this one: enter image description here

These saws cut very smooth and are made by Xacto. Should be available from most serious hardware stores and craft centers.

One Source:


Many types of plastics can be sanded with very fine sand paper. You want to look for a product known as "wet or dry" sand paper with a grit number up to 1500 or more. If the cutting operation leaves some saw kerf marks on the stub of the peg you may need to start with a courser paper and then work your way up to the highest numbered grit to get the polish you desire. The Silicon Carbide type wet-dry sandpaper should be available at good hardware stores. Sometimes you can also find this at auto parts stores.

share|improve this answer
Just a quick note (as I use these from time to time) these saw blades are not bi-directional. You only get a cut on the pull. –  Edwin Buck Sep 25 '12 at 12:27

As a follow-up to the advice about using very fine saws and super fine sandpaper, jewelers rouge is often used to do a final polish on plastic to get to a clear finish.

jewelers rouge

share|improve this answer
A good choice if you don't want to deal with heat assisted cutting. –  Edwin Buck Sep 24 '12 at 14:27

Depending on the type of plastic, and the thickness / dimensions of the cut, a hot knife or a heated wire knife might be what you are looking for.

There are many ways to go about rigging a hot knife, the simplest being to attach an xacto knife blade to a soldering iron. Larger jobs might require a purpose built tool, or at least a much better setup.

Another option is to get the cleanest cut you can, and experiment with a heat gun to soften the cut area. Again, even heating without burning is key, and some plastics are easier to work with than others.

Keep safety in mind, plastic burns giving off very nasty fumes. Most people die on airplanes due to plastic fumes far before any in-plane fires reach them. While you (hopefully) won't scorch your plastic, even heating it should be done with ample ventilation (preferably outdoors).

share|improve this answer

If you are working with acrylic you should check these technical bulletins for information about how to work with arcylic.

I have successfully used a tablesaw to get a good straight cut then used a variable speed bench jointer to smooth the edge. I was working with 1/4" and 1/8" thick acrylic and resulting parts were all rectangular and more than 1" in each dimension.

If you don't have a jointer you might be able to use a bench mounted router to get a smooth edge but I haven't tried it myself.

I tried other methods for cutting the acrylic but only the table saw could gave me consistently straight cuts. (I tried a band saw, jig saw and the score and snap method)

share|improve this answer

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.