Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I fitted a new tap and waste outlet to a small basin, because the new outlet is shorter than the old, the plastic pipework no longer reaches (see photo) I can force the parts to mate but I don't like having the pipe under a lot of strain and it doesn't seal properly (I havent tried applying copious amounts of plumbers putty).

pipework

I am considering cutting off the white-painted down-pipe (at right of photo) and using a solvent-weld straight coupling to insert a new section of pipe to raise the pipework about 1 cm.

The existing pipe has an outside diameter of 36 mm.
The pipes available in catalogues are listed as 32 mm or 40 mm.

I understand that a nominal 32 mm plastic waste pipe has an outside diameter of 34.5 mm. Is this the right pipe?

share|improve this question
1  
I am a little concerned about those 2 90 degree bends that are visible. Those look like vent 90s that should not be used to waste. IMO they should be smoothe bends instead of sharp corners. –  auujay Sep 17 '12 at 13:12
    
@auujay: Thanks for taking the time to respond. I think this may reflect a difference in plumbing practices in the US and UK. The bend on the left is part of a standard "P trap" basin waste outlet (example) and the bend on the right is also a fairly common part marketed for basin waste pipes (example) –  RedGrittyBrick Sep 17 '12 at 14:32

2 Answers 2

up vote 1 down vote accepted

enter image description here

Cut where marked, but adjust the location so you've got clearance to work later.

Seeing as you only need a couple of millimeters, you might be able to get away with buying only the coupling connector similar to this:

enter image description here

So a good straight cut where marked, insert the connect and solvent weld it back into place.

Take the cut piece in with you, and just make sure you've got a snug dry fit in the store. No need to actually figure out the exact diameter. Just buy the piece that fits.

share|improve this answer
    
Thanks, I guess I'll have to try sanding off the gloss paint from the pipe before welding. –  RedGrittyBrick Sep 17 '12 at 15:35

So far I have discovered there are at least two incompatible types of "32mm" plastic waste pipe.

  • "solvent weld" PVC or ABS pipe with an inside diameter of 32mm and outside diameter of ~37mm.
  • "push fit" plastic pipe with an inside diameter of ~29mm and an outside diameter of ~35mm

Because of the difference in diameters, you can't use push-fit fittings on "solvent weld" pipe and you can't use solvent-weld fittings on push-fit pipe. I guess this is deliberate to stop people trying to use solvent to weld a pipe made of a material that the solvent won't melt.

Diameters above are approximate measurements made with a cheap vernier gauge.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.