Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I noticed that two panels of my laminate floor board have not joined well: there is a small gap between them. Now, it seems that constant wear is damaging the edges of the board.

enter image description here

Is there any way to repair this? Basically I would like to seal the gap to stop the chipboard edges from getting more damaged.

Potentially I was thinking of using some kind of glue/sealer/enamel that I could fill into the gap. (I thought to use a Stanley blade to cut a constant V into the edge, then fill.)

share|improve this question
add comment

2 Answers 2

up vote 1 down vote accepted

It wouldn't be a true seal, but if it's not in a high-traffic area, you might be able to trim any flaking bits and then de-emphasize the gap left with wax putty.

I wouldn't attempt to cut the board out; trying to get a new board back in is likely be more difficult to get looking correct, as you potentially have 4 edges to contend with; you can sometimes deal with it if it's true tongue-and-groove, but the click-lock's much more difficult to get down correctly.

share|improve this answer
add comment

You can use a very thin blade like that on a multi-tool to cut out the damaged piece, then drop in a replacement piece to fit, gluing it down solidly underneath.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.