Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I'm putting in a "hanging chair" in the basement and it's supposed to hang from a single hook in the ceiling. The ceiling is reinforced concrete.

Now, I'm about 125 kilograms (275 lbs) so I reckon the hook should easily be able to bear twice that for safety. Is that a good enough margin?

What would be the easiest and best way to mount a hook in the ceiling that will hold about 250 kgs (550 lbs)?

share|improve this question
1  
2x margin seems low. People tend to hang/swing on stuff way to much. Also what is behind the concrete? I.e is it a poured ceiling, is there structure in there, a beam, etc? –  Alex Feinman Sep 8 '10 at 20:41
    
I think it's just poured concrete with rebars in. –  henriksen Sep 9 '10 at 9:03
add comment

3 Answers 3

up vote 4 down vote accepted

I'd recommend a concrete epoxy for this application. It's expensive at $19 but is stronger than a mechanical anchor, and you can sink a standard eye bolt in there for a nice clean look. I'd recommend a heavy 1/2" one like this -- that one is 6" long, but if the ceiling is thick enough you could bury most of it in your hole so just the eye is exposed.

share|improve this answer
    
Thanks, just the kind of info I was looking for –  henriksen Sep 9 '10 at 8:54
add comment

I know that mechanical anchors are mentioned, however i would have simply used a rawl-bolt of sufficient diameter for the task.

This would be dependent on the quality/strength of the concrete.

enter image description here

share|improve this answer
add comment

Your margin of error sounds a bit low - one thing to bear in mind is that while the static force of you in the chair is half the rating of the hook, the peak force will be higher as you "drop" into the chair. If you can get a bigger hook it might be worth it.

If you have a hook on a plate then you'll spread the load across more bolts thus each one won't have to bear the full weight.

share|improve this answer
    
Good idea. I was going to say the hook will be the weak link too. –  nportelli Sep 8 '10 at 20:49
    
Thanks for the input. What kind of margin should I go for? 3x, 4x? I like Mike's idea of sinking a standard eyebolt in, it will look nicer. –  henriksen Sep 9 '10 at 8:58
1  
@henrikson - I don't know for certain, you may be limited by what you can actually buy. Perhaps you should go for the largest you can afford. –  ChrisF Sep 9 '10 at 10:35
    
Thanks! Appreciate the help guys! –  henriksen Sep 10 '10 at 12:21
    
+1 for spreading the weight around with a plate –  Brad Nov 8 '12 at 4:39
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.