Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I have a brand new countertop dishwasher with a faucet adapter that connects the faucet with a hose going into the dishwasher. Both my faucet and the faucet adapter are double threaded (inside and outside) but the sizes of the threads on my faucet are not compatible.

I have gone to Home Depot and tried various size adapters, which seem to come in the sizes 3/4,55/64, and 15/16 inch (increasing order). My sink is between a 55/64 and a 15/16, and the faucet adapter is 15/16 inch.

So given that a direct fit isn't possible, what is the best way to make the connection? I have tried thread seal tape but I can't get a fit tight enough. Will super glue help, or is there something better to make the connection? (I'll need to remove the adapter when I move out.)

share|improve this question
    
Sounds like your sink tap's thread is metric, actually. –  staticsan Aug 27 '12 at 1:33

1 Answer 1

Take the aerator from your faucet and the adapter from your dishwasher to a plumbing supply store. They will have a bigger selection of sizes. It is possible you have an unusual faucet that HomeDepot doesn't carry. Do not use superglue. If you do anything to alter the fixture you could be responsible for replaceing it when you leave.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.