Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

How can I keep my router aligned correctly when using it with the base against the edge rather than the face of a board? Is there a jig or attachment I should use? Freehanding clearly doesn't cut it.

share|improve this question

1 Answer 1

up vote 7 down vote accepted

I'm not sure if I really understand the question, but I think you are trying to shape the edge of a board by running the router against the narrow edge instead of the wide top/bottom. If this is the case, there are a couple of ways to keep the router steady and perpendicular to the edge. The best way is to mount the router in a table and run your stock against the guide/fence. If you don't have a router table, you can clamp some larger stock like a 2X4 to the board to make a wider edge for the router to slide on. This will help keep the router platform flat to the work.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.