Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I just want to make sure this wont hurt anything.

Right before I bought this house, it got a new AC and furnace but they did not replace much of the duct work. This vent is right above the AC unit and is the first vent the cold air passes. It was bleeding cold air into the basement so I covered it.

enter image description here

share|improve this question
2  
You probably want at least one vent down there, but yea, probably not there. Also note that duct tape is (ironically) not designed for ducts. –  DA01 Jul 5 '12 at 17:37
add comment

1 Answer

up vote 7 down vote accepted

Whether you tape it or otherwise block it, the effect will be the same and it will not cause any damage to your system; it would be no different than if there was a standard register there that was closed.

The only thing I'll note is that duct tape will eventually dry up and fall off. Ideally you would use foil HVAC tape

HVAC Tape

Unlike duct tape, this will not dry up and will hold the seal.

share|improve this answer
    
Thanks. I was planning on getting some foil tape (as long as I got no feed back on this damaging the system) this weekend. But at 103 outside I just grabbed the first thing I saw –  zk. Jul 5 '12 at 18:53
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.