Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I'm re-insulating a room in my house, and have come to the corner. The studs are arranged like so:

x| | |
-
-

x = the space I'm talking about, | = studs of an interior wall, - = studs of an exterior wall.

Peeking in, I can see there is some loose fibreglass insulation in there.

Question: What should I do about that space? I can see 3 possibilities

  1. Try to rip out as much of the existing insulation as possible (maybe with a linoleum knife?), and try to re-fill with Roxul (the insulation I'm using for the rest of the project.
  2. Same as 1, but fill the space with Big Gap Filler
  3. Don't try to remove the existing insulation, and just stuff a little more Roxul in there.

What would people who actually know what they're doing suggest?

share|improve this question

1 Answer 1

up vote 5 down vote accepted

I wouldn't attempt to remove the existing insulation unless there's a health hazard (e.g. mold). It was put there during the middle of framing because of how difficult the space is to access. My personal solution would be to spray a little big gap filler in there because it's designed to expand and provide an airtight seal. Other types of insulation, like fiberglass and Roxul lose their effectiveness when compressed. Much of the insulation in them comes from trapping air in pockets. So you'd get less efficiency after cramming it through a small crack.

share|improve this answer
    
Big gap filler it is. Thanks. –  Pickle Jul 5 '12 at 22:23

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.