Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

Is there any danger of bad fumes/gasses being released from polyisocyanurate or polystyrene rigid foam insulation? I'm planning on insulating my bedroom from the inside (ie: putting the insulation between the studs), and I'm wondering if I need to worry about fumes over the years.

My guess is there's no issue, as people use this stuff all the time, and my vapour barrier will prevent any air movement anyway. Still, it was brought up by a hardware store I called, so I'd like some sanity-checking opinions.

Edit: Since I've been able to find precious little information on insulating the inside of exterior walls with rigid insulation, I've decided to go with Roxul (fibreglass-ish) insulation instead.

To answer my question though, I've asked people IRL, and they pretty much scoffed at the idea that rigid foam insulation gives off fumes.

share|improve this question
    
the stuff if pretty nasty if it burns, but is a common insulation material for all sorts of approved uses. BTW, you don't want to use foam insulation AND a vapor barrier. Foam insulation is typically considered the vapor barrier. –  DA01 Jul 3 '12 at 22:55
    
Ya, I've heard it's nasty, and code requires it be covered by a fire barrier - drywall suffices. From what I've read, foam insulation is a vapour retardant (if I'm using the right terminology), not an outright barrier. I'm getting conflicting reports about foam & VB, so I'm going to ping a local contractor. Nonetheless, thanks for your reply DA01 - not the first I've valued today. –  Pickle Jul 3 '12 at 23:02
    
Foam insulation could be a vapor barrier if it is continuous but pickle will be cutting it into 14.5" pieces and putting it between the studs. There will be lots of gaps between the hand cut foam and the irregular wood studs. –  Philip Ngai Jul 4 '12 at 17:05
    
The two answers so far illustrate the gulf between the manufacturer's stance and the viewpoint of those concerned with indoor pollution, many of whom suffer from various hypersensitivities. You'll end up deciding for yourself if this will be tolerable to you. A well installed vapor barrier will help significantly if the outer wall materials allow the gases to escape in that direction. –  bcworkz Nov 27 '12 at 19:41
add comment

2 Answers 2

According to the Material Safety Data Sheet (MSDS) for TRYMER(TM) 3000 Rigid Polyisocyanurate Insulation, there should be no problems (for this specific product anyway).

I also found the MSDS of an example Expanded Polystyrene Board, which does mentions off-gas issues. Though it only applies to large amounts of "fresh" polystyrene, being stored in a "confined, unventilated area".

fresh polystyrene contains residual pentane and if large amounts of EPS materials are stored in a confined, unventilated area such as a semi-trailer truck, pentane may off-gas and create measurable airborne concentrations.

If you know the specific product you'd like to use, it shouldn't be that difficult to find the MSDS for it on the internet.

share|improve this answer
add comment

Yes, foam board offgasses. All plasics, some woods (pine), wood products, paints and adhesives do. Some offgas products are more of a concern than others. For example, the formaldehyde emanating from OSB, MDF, particle board and plywood is perhaps the single greatest hazard in North American homes today. It has long been associated with increased risk of asthma and cancer. Our new super-insulated home has none of these wood products and our last home, also processed-wood product free, sold above market value because it was so free of contamination.

Foam board releases small amounts of brominated flame retardants, and this is a serious concern. I personally would not use foam board indoors. Having said this, flame retardants are in damn near everything: all upholstery materials, draperies, mattresses, carpets.....I'm finding this to be even more difficult to eliminate than formaldehyde. The fact is, most of us are exposed to more danger breathing in our own homes than outside in our polluted cities.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.