Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I've done a bit of studying around and I think I've grasped the basics, but if you could walk me through more nuances of spray painting, I'd greatly appreciate it.

Objective: Spray paint on steel (and a little bit of plastic) for:

  • semi-gloss finish
  • high durability (chip, scratch, rust resistant)
  • wet-cleanable (I think the semi-gloss coating should allow this)

My current procedure:

  • Cover areas not to be painted with paper and tape.
  • Scuff the surface down with 100-grit sandpaper. [1]
  • Wipe clean.
  • Prime. [2]
  • Apply color coating. Let dry.
  • Sand with 400-grit and apply another coat. 400-grit sand again. [3]
  • ???
  • Finished.

[1]: How do I know when I'm done with this pre-processing step? Do I have to scuff and remove the manufacturer's coat until I see the bare metal? Or do I just remove a significant part of it? If you feel like you have time, can you name some reasons why I would want to do this? I imagine my primer/coating would stick better to metal than on top of another coating, but I'm not sure.

[2]: How much priming is enough? Should I be picky about primer choice?

[3]: I presume that this process gives the semi-glossy finish I want, but I don't see how multiple coat + fine sanding is going to achieve it. Will it really? Or do I finish with the color coating first, then apply a glossy enamel coat on top?

share|improve this question

closed as off topic by Jay Bazuzi, BMitch, Niall C., ChrisF Jun 14 '12 at 19:02

Questions on Home Improvement Stack Exchange are expected to relate to home improvement within the scope defined by the community. Consider editing the question or leaving comments for improvement if you believe the question can be reworded to fit within the scope. Read more about reopening questions here.If this question can be reworded to fit the rules in the help center, please edit the question.

add comment

1 Answer 1

up vote 4 down vote accepted

I did spraypaint a computer case a few years ago. It was glossy and I could see my reflection in it, but not as scratch-resistant as I hoped.

Question 1: You need to scuff to remove the smoothness of the steel and plastic to give the primer a surface to stick to. No need to go back to the bare metal.

Question 2: It depends how smooth you want your final result to be. Your end-result will be as good as your priming job. Prime, wet-sand with 1000grit paper, dry, repeat. I did this until I had removed all the "orange peel" feeling to my surface. (Took 6 or 7 coats) I used store-brand automotive primer and paint.

Question 3: This process give the smooth finish. The more coats/sanding you do, the smoother and glossier it will be. I used 1000grit for the first 3 coats, and then 2000grit for another 3 coats of paint.

The ??? step:

  • Apply a few coats of clear coating. That's what I didn't do back then.

  • When dry, polish it with car wax.

share|improve this answer
add comment

Not the answer you're looking for? Browse other questions tagged or ask your own question.