Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I have a cloth drying stand (or cloth drying rack) which is of ceiling mounted type. What happen was that one of the edge fall off and another edge was like hanging up there, waiting to fall off anytime.

The cloth drying stand look similar like the one below:

Hanger

Is there anyway to fix it? or are there better alternative that is very easy to install on ceiling and is portable (which mean that I can place it anywhere)?

share|improve this question
    
When you say ends do you mean the parts that go from the clothes stand to the ceiling? –  lqlarry Mar 22 '12 at 2:43
    
@lqlarry, Yes, the part from the cloth stand to the ceiling. (not referring to the blue strings but the blue handle. By the way, mime don't have the white metal in between or in the center. –  Jack Mar 22 '12 at 5:00
    
Show a picture of yours. –  Calvin.Allen Mar 22 '12 at 15:56
    
The only thing I can say from seeing the picture and your description is take measurements and see if something like 1/2 EMT (thin wall electrical metallic conduit)in the electrical department at a hardware store will slip over the square tubing and then put some screws in it to keep it from falling apart. You can get square tubing but it would probably cost too much. –  lqlarry Mar 23 '12 at 1:32
    
Actually I feel like removing the whole rack and replace with new ones that are portable and can be mounted on the ceiling. Any ideas which ways is better? - screwing / drilling it back or getting new one that are portable and can be mounted on the ceiling? –  Jack Mar 23 '12 at 9:21

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Browse other questions tagged or ask your own question.