Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I am putting up some crown molding on top of some existing cabinets, but I only have about 12 inches of clearance. In the past when I have done projects like this, I have used a finishing nailer or brad nailer, however with this space, the tool won't fit.

What options or tool can I use to attach crown molding in this limited space?

share|improve this question

4 Answers 4

up vote 4 down vote accepted

You can also use a nail spinner on the end of a drill. It's a small tool that chucks into the drill. Put a nail into the end of it and it spins it into wood. A final tap with a nail set puts the nail below the surface. It's a cabinetmakers tool and it prevents splitting the wood when driving finish nails into moldings (particularly oak).

http://www.craftsman.com/craftsman-nail-spinner/p-00902601000P

I wouldn't recommend using the palm nailer.... They're not easily controlled and you risk damaging the molding itself.

share|improve this answer
    
In this case, to get the crown molding on top of the cabinet, I used a 90 degree drill (only needed 4 inches of clearance) and screws to get it in. I did this before I knew about the nail spinner and will add that to my list of things to try next time. –  Tim Koscielski Mar 19 '12 at 6:15

You could use a good construction adhesive to glue it in the areas you cannot drive a nail through. Make sure to use a scrap piece of molding to wedge the piece against the wall until the glue dries.

share|improve this answer
    
I was putting crown molding on the top of a cabinet and not attaching to the wall, but thanks for the idea. –  Tim Koscielski Mar 19 '12 at 6:18

I have the Rigid JobMax multi-tool with the Auto-Hammer head, which works in tight spaces. You'll have to set the nails below flush by hand though.

share|improve this answer

A palm nailer might work.

Palm Nailer Image

share|improve this answer
1  
I did try the palm nailer, but as someone mentioned, I ran into problems. First I bought a cheap one which had its issues. I then bought a Rigid that worked much better and I had some better control, but the wood was too hard for nailing. I kept bending nails. In the end a 90 degree drill and screws did the trick with pre drilled guide holes. –  Tim Koscielski Mar 19 '12 at 6:16

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.