Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

When installing my vinyl windows should I put a nail into every little hole around the window? It has a flange that has many little holes around it. Also what size nails would you recommend? Finally do I need to secure the window to the inside of the rough opening, as you do with a door?

share|improve this question
1  
Check out the site blog entry about replacement windows for pictures and tips. –  Steve Jackson Mar 12 '12 at 15:35
    
This question should be edited to reflect new construction installation versus replacement windows. My answer below is based on replacement windows. The installation methods differ. –  Jon Raynor Mar 12 '12 at 21:06
    
He talks about the nailing fin ("flange") in the question - so these are not replacement, they are new contrustion windows. –  dbracey Mar 12 '12 at 22:56
    
@Dbracey - Thanks for the clarification. –  Jon Raynor Mar 13 '12 at 12:49

3 Answers 3

up vote 2 down vote accepted

Yes put a nail into every hole. I would recommend galvanized nails that are 1 to 2 inches in length. If there is nothing behind the flange but plywood, anything over an inch and the nail will just be sticking through the plywood.

I assume you will hit some framing behind the playwood, so a little longer and you will hit that. I looked over my new vinyl windows in my sunroom and there are no attachment points on the inside of the window.

I don't recall doing anything on the inside of the window when installing. The most important point I remember was with the flashing on the outside. Start at the bottom, then the sides, then the top so that water can be properly channelled away. There is a video below in the comments showing an installation. I remember it was pretty straight forward, just made sure the windows are level.

share|improve this answer
    
The windows I am installing is in a new rough opening, no pre-existing windows. –  Kevin Mar 12 '12 at 20:39
    
OK, for new rough opening it is definatley different than replacement windows. –  Jon Raynor Mar 12 '12 at 20:45
    
This is for new windows. youtube.com/watch?v=j8xY5QKVU9s&feature=related , I would fill every hole, looks like a 1.5" galvanized nail. –  Jon Raynor Mar 12 '12 at 20:57
    
If you have the model number off this window, go to the manufacturer's website and look up their installation instructions. Milgard, Jeld-Wen, et.al. are pretty explicit in how to install a window so it meets their warranty. Usually, they want you to use roofing nails and put them in every other hole. Vinyl expands and contracts, this allows for it to happen. There's a flexible flashing and caulk routine as well to prevent leaks. –  Fiasco Labs Apr 8 '13 at 15:45

From personal experience, installing a nail in every hole is wasting time and materiel. Most instructions recommend every other hole, which will cover any unlikely warranty issues.

A good resource for this question can be found at This Old House. I find that "This Old House" is a great resource for learning the proper way to accomplish construction tasks. Keep in mind that they do not share any shortcuts...

share|improve this answer

Yes, I'd recommend putting a nail in every single hole, roughly 1.5 inches in size. I believe what you have are new construction windows because they're equipped with the nailing flange along the outer frame. Typically, vinyl replacement windows don't come attached with this kind of flange for easy installation.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.