Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

My sump pump recently went bad and while replacing it, I also decided to replace the plastic corrugated tubing that was connected to it.

When I turned on the new pump, the amount of noise it was making sounded like there was an elephant in the basement. Best I could tell, that noise came from the corrugated tubing getting into some resonating vibration. After wiggling things here and there, I removed the new tubing and put the old one back in and now the pump is as quiet as a mouse.

As far as I know, this is a standard corrugated tubing for use with sump pumps that I bought from the local hardware store. But it appears to be made of a slightly harder plastic than the old tubing and I think that is partially why vibration noise is so much higher.

Is there anything that can be done to eliminate the noise besides having to use really old tubing which I would like to replace at some point?

share|improve this question
    
natural frequency = sqrt(k/m) where k is the stiffness and m is mass. So if the old tubing wasn't vibrating, increasing the mass on the newer stiffer tubing should lower the natural frequency back down to where it was before. –  Doresoom Apr 11 '12 at 19:02

2 Answers 2

You might try insulating a section of the pipe with foam insulation.Then try to mount that to something solid like a section of 2x4.

share|improve this answer
1  
You can also try isolating the sump pump from the plastic pipe with a section of rubber pipe of the proper diameter; a hose clamp and some sealant on either side of a short length will absorb some vibration that would otherwise be transmitted directly from the pump housing into the pipe. –  KeithS Mar 13 '12 at 0:10

You could replace the corrugated tubing with smooth black plastic pipe in the same size as your corrugated pipe. It bends slightly, but you will also probably need a 90 degree elbow to make the turn from "up" to "out". Although it fits on the connectors pretty snugly, be sure to get hose clamps for all of the connections; it would be a bad day if one of the connections eventually came apart.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.