Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

We have an old staircase (1900s) and after removing the carpet, before we get the new one fitted, we noticed that one of the corner steps has a lengthways split right down the middle:

Photo of crack in stairs

How easy would it be replace the step? Or alternatively would it be possible to toughen it up? One person suggested to use a thin piece of hardboard on top of it to spread the load.

I have booked out a joiner for tomorrow morning but now wondering whether I should just leave the step alone. I haven't used the joiner before so don't want him to just crash & burn to make some money so would really appreciate some advice. When I walk on the step it gives less than 1cm. There is no access to the stairs underneath.

share|improve this question

1 Answer 1

up vote 3 down vote accepted

If the tread is loose enough to close the gap by tapping it with a hammer you may be able to glue it .If it is loose take two 3/4x3/4 inch boards that are as long as the crack.Drill four holes thru both boards big enough for a 10-24 screw.With some dry wall screws attach the boards to the tread on both sides of the crack.Apply some gorilla glue to the gap. Using the 10-24 screws draw the gap closed, allow the glue to dry, remove the 3/4" boards.Sand any glue squeezed out.

share|improve this answer
    
thanks. in the end we glued the gap and then attached a piece of hardboard on top. seems to have worked well. new carpet now installed and feels great! –  xylar Mar 12 '12 at 23:02

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.