Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I'm replacing some old 1970s railing in between my kitchen and family room (there's a step down into my family room.) I ripped that out and exposed what looks like a stair tread that was ripped down and used for the step-down edge. I pulled that out because it was beat up and we are changing stain colors. In the pic you can see the "anatomy" of what I'm working with:

So the edge sits on the joist and the fascia board. (It was glued/nailed to the joist.)

Now my problem is that I need to get the other section out. It looks like the linoleum is sitting on top of it...so how can I get that out and not damage the linoleum? Undercut it with my multitool saw? Or is that a fool's mission and should I attempt something else?

share|improve this question

1 Answer 1

You can try heating a section near the edge with a hair dryer to see if it softens the adhesive.If you are lucky only the edges were glued.Use a stiff joint knife to gently lift the edge.

share|improve this answer
    
I think it's likely impossible. But, if anything will work it'll be this. –  Chris Cudmore May 9 '12 at 12:36

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.