Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I am building a dividing half-wall/shelving unit to separate my living room from entrance door. I am planning to put a bench on the side closer to the door (so me and my guests can sit down while lacing shoes) and I am wondering about what kind of material should i use for this bench?

Approximate dimensions will be 3-4 feet length(or width), 16 inches deep and 17 inches from the floor.

I want to make sure that this bench can withstand big loads (some of my friends are big) I was thinking about using 1 inch thick plywood sheet on top of 2 2x3s, but I am not too sure about it. I also don't want it to be too thick or have some posts in the middle, because I want to be able to put shoes under it.

Can someone recommend what materials should I use and possible construction of this bench (or point in right direction) ?

share|improve this question
    
@tester101 - Thanks for editing title of the question, but it changes the meaning of the question, makes it blurry. I am specifically looking for materials and (maybe) designs, so i would like to include word materials in the title –  Sasha Feb 8 '12 at 20:16
1  
Is this bench going to be cantilevered out from the wall or will there be supports at the end? –  auujay Feb 8 '12 at 21:08
1  
You could probably use plywood ripped to 3" and glue them together for your supports, and maybe put a trim skirt of plywood around the top that is the size of the supports plus top...or even trim it with a better piece of wood. –  lqlarry Feb 9 '12 at 2:58
add comment

1 Answer

Take a look at these Standardized Work Table Plans as it might give you some ideas. Obviously you would not need the lower shelf, but otherwise it would be similiar (but scaled down), and this thing can hold a lot of weight!

Table Top Design

share|improve this answer
    
thanks, it is nice. however I would like to avoid using 2x4s as they consume too much space...Would it work with 2x3s or 2x2? –  Sasha Feb 8 '12 at 20:46
    
I think the key with a plywood top is just ensuring its adequately supported below so that it does not sag and crack. If you are worried you can space the supports closer together while going down in size. –  Steven Feb 8 '12 at 21:04
    
Based on @Steven design, I would probably add chain going from the corners opposite of the wall, at 45 degrees, connected to the wall using some sort of eye bolt and washers (making sure to hit the frame in the bench and studs in the wall). If there's no support for the bench below, and your friends being on the bigger side, you'll need something to support the weight and not rip it from the wall. That would leave the below perfectly clear for shoes and storage. –  lsiunsuex Feb 9 '12 at 12:11
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.