Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I am installing a new linoleum floor in a small bathroom (approx. 6' X 6'). This is a replacement for an old linoleum floor. The replacement will be a single piece.

Talking with the local big box store flooring expert, he recommended not gluing it down.

It would be tempting to not glue it down since the linoleum floor will be a single piece and will be held down on all sides. But while I would love to make things easier for myself and not use glue, I am not so sure this is a good idea.

Would it be a bad idea to not glue down the linoleum floor?

share|improve this question
    
Did the "expert" say why not to glue it down? –  Niall C. Feb 2 '12 at 16:14
    
Not really... just that it is held down on all sides. Sounds like you are skeptical, just like me. –  Jeff Widmer Feb 2 '12 at 16:28
1  
I'd be afraid of wrinkles and/or bubbles developing over time. –  Tester101 Feb 2 '12 at 17:13
3  
What are the manufacture's installation recommendations? –  auujay Feb 2 '12 at 19:19
add comment

3 Answers

The "free floating" sheet vinyl works fine, I've laid it a few times and have never had a complaint...pretty quick and easy as well. If you want to use an adhesive, which is most likely the smart thing to do for added longevity and protection against natural movement/wrinkles, you do not want to perimeter adhere. You must use adhesive over the entire subfloor for it to properly lay. And, as previous posts have mentioned, with the fiberglass backing you must use a pressure sensitive adhesive.

share|improve this answer
add comment

Make sure you have the right vinyl flooring that does not require glue/adhesive and you do decide to use the adhesive make sure it is the releasable pressure sensitive adhesive. Good luck

share|improve this answer
add comment

There is a whole new generation of fiberglass, not vinyl, flooring that is self laying. The various manufacturers say wit will lay flat, not curl or bubble without adhesive. I have my doubts, but admit I have not used it without adhesive. The manufacturer does says that when adhesive is used, it can only be "Releasable Pressure Sensitive Adhesive", never standard vinyl sheet goods adhesive.

In a small room like you have, I'd test the no glue theory. If it doesn't work well, it's easy enough to go back and glue it down with pressure sensitive adhesive.

share|improve this answer
    
Exactly, apply glue later if you think it's needed. Easier to apply glue later than try to remove it. –  Matt Jul 11 '13 at 22:27
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.