Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

My second in the line of "redoing a bathroom" questions. For our tub surround, my wife and I have picked out some very nice 16"x4" subway tiles, that we would like to arrange in a brick pattern. To surround the tile, and finish exposed edges, we have ordered some 16x4 bullnose. For example:

However, in order to have a brick pattern, every other row will require a 16x4 tile to be cut in half, leaving an unfinished edge on the tile. I have noticed that the tile we picked out has a very slight roundness to the edges of the tile. Cutting the tile in half will cause a sharp corner where the cut tile butts up against the bullnose:

The top is a full 16x4 viewed from the edge (notice the rounded top edge where it butts against the bullnose) whereas the bottom is the cut tile (notice the sharp corner where it butts against the bullnose). Now, in this image I have exaggerated the bevel on the top face of the tile, it is quite a bit more subtle than this.

How is this typically handled? Is there a way to soften the sharp corner? Or is it typically not noticed?

share|improve this question
add comment

1 Answer

up vote 3 down vote accepted

In my experience it's usually not noticed.

You'll be grouting as well and unless you're very precise with the grout there'll be some variation with grout depth and width which will "even out" the effect.

share|improve this answer
    
Thanks Chris, I was hoping that would be the case, and these tiles were not cheap, so I'd prefer to hear experience such as yours before cutting into them ;) –  MarkD Aug 10 '10 at 15:02
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.