Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

My real question, after several hours spent removing the old faucet (progressing from tapping the basin wrench with a mallet, to an overnight soak in penetrating oil, to cutting it off with an air grinder) is "what idiot engineer uses a mild steel washer in a wet environment?" But it looks like they all do, or at least the ones who designed the new faucet do, so ...

On the assumption that I or someone else will someday want to change the faucet, what can I use to prevent the nut from freezing to either the washer or the faucet body? If I were working on a car, I'd use thread sealing compound. Does that make sense in this application? Or are there any professional tricks that aren't quite as messy?

share|improve this question
add comment

1 Answer 1

Anti-Seize Lubricating Compound

Make sure it's waterproof

enter image description here

Pipe Dope

Make sure it's Anti-seize

enter image description here

I do not specifically recommend nor endorse either product, they are only used as examples.

share|improve this answer
    
I worried this would be the answer. +1, but I'm still hoping that someone else will come up with something less messy in the next couple of hours :-) –  kdgregory Dec 22 '11 at 21:26
    
@kdgregory Messy? I think you're using it wrong. –  Tester101 Dec 22 '11 at 21:31
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.