Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I have a Whirlpool Gold Conquest side by side refrigerator, Model #GS2SHEXNB00. Here's the tag:

tag

It has a line that runs through the freezer door to the water dispenser in the front. Water has started to slowly drip down the line and pool at the bottom. I am guessing there is a crack in the line somewhere inside the door, but I can't figure out how to get at it.

dripping line

I'm fairly certain that I need to remove the ice/water dispenser to get at the line:

water/ice dispenser, cover removed

I've managed to remove the faceplate and there are four screws at the corners of the dispenser, but after removing them, it still doesn't budge. I think there may be some sort of glue holding it in. I've worked a knife around the edges and loosened them up, but it's still pretty firmly in there.

How can I get that thing out of there? Or is that even the right place to replace the water line?

share|improve this question

1 Answer 1

up vote 3 down vote accepted

To replace the water line, you need to remove the entire door - the water line from the dispenser runs through it.

The water line from the dispenser is one continuous piece through the door. By disconnecting it at the dispenser, you can pull it out the bottom of the door.

share|improve this answer
    
So I have to replace the entire door? –  noah Dec 18 '11 at 22:15

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.