Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

The floor joists of the first floor are sitting directly in breaks in the concrete/cinderblock walls, and there's large gaps all around the edges. I've done some looking around and it appears that these are a large source of air loss, so I need to insulate them. Can I just spray some expanding foam in that area, or is it better to get some rigid foam, cut it, and then just use foam to seal the edges where it meets the joists/wall? What about a vapor barrier? enter image description here enter image description here enter image description here enter image description here

share|improve this question
1  
Pictures would be helpful. Do the gaps lead to the outside? –  Tester101 Dec 5 '11 at 20:37
add comment

1 Answer

up vote 6 down vote accepted

The Family Handyman recommends using rigid foam, caulk, and spray foam to insulate the rim joist, in this article Insulate Basement Rim Joists.

enter image description here

Not sure if this is exactly what you're looking to do, but the idea should work in your situation I think.

Summary of steps:

  • Cut rigid foam to fit between joists.

  • Insert foam into gaps (against rim joist).

  • Caulk around the edge of the foam.

  • Fill any gaps in the rigid foam where pipes or vents pass through, with spray foam.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.