I just drained my water heater to flush out any sediment that may have accumulated at the bottom of the tank. When I filled it back up, I suddenly am lacking water pressure, both cold and hot, at all of the faucets of my house. What would cause this?
Tell me more
×
Home Improvement Stack Exchange is a question and answer site for
contractors and serious DIYers. It's 100% free, no registration required.
|
I assume when you drained the tank, you turned off the main cold water supply. I suspect that the cold water valve is not opened all the way now. Check to see if in fact it is open full. If it is, and the pressure is still low, you may have a jammed or damaged valve. This is very common on old valves that are not used very often. The seats and washers inside the valve can degrade over time and now are not allowing water to pass freely. |
|||||||||
|