Take the 2-minute tour ×
Home Improvement Stack Exchange is a question and answer site for contractors and serious DIYers. It's 100% free, no registration required.

I live in an older house (California) and the overhead light fixture boxes seem small. They unreceptive to the fixtures my wife has purchased from Ikea in that they have two holes for accepting screws and no amount of cajoling the Ikea fixture will cause its holes to line up. I've picked up an adapter plate from a hardware store but none of its holes line up with the fixture's holes either. Am I doing it wrong?

share|improve this question
2  
can you post some pictures? –  staticx Aug 5 '10 at 15:48
    
Not receptacle- box. I was confused by that at first... –  nstenz Aug 26 '10 at 3:25
add comment

2 Answers

up vote 7 down vote accepted

Usually you will have some sort of strap (as shown in the pictures below) which will go over the receptacle box and then the overhead light will attach to that.

alt text alt text

share|improve this answer
    
I will go look for a strap on the old fixture –  Ron Aug 5 '10 at 16:23
add comment

If it's not a standard junction box, you could always replace it with a new one. A standard octagonal junction box should do the trick:

alt text

If the old box wasn't located near a ceiling joist, I'd recommend something like the Westinghouse Saf-T-Brace. You don't even need to go into the attic to install it. (You do need to know which way your ceiling joists run though.)

alt text

share|improve this answer
    
Thank you for the product suggestion. If I can't find a strap which is compatible with my box & my fixture then I'll definitely look at the saf-t-brace. –  Ron Aug 5 '10 at 16:24
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.